Wall Panel Inside Corner

Wallpanel Inside Corner
MINE FAVORITTER

No Fibo favorites here yet.

    1. Wallpanel Inside Corner

    A)
    Inside corner profile
    Installation of the base profile Install the base profile about 60 - 80 mm from the floor, by applying sealant to the lower end on the back side of the profile, and screw it to the wall. This applies to both the base profile and the corner profile.
    To make sure the profile is level, it is recomended that you use a level or a laser.
    B)
    Fitting the internal corner
    Always start installattion in a corner, from left to right.
    Inside part list must be attatched in both lower folds.

    C)
    Fitting the first panel
    Make sure the panel is level, before you meassure top and bottom of first panel.
    Remember to meassure in to the profile and to the first stud.
    Cut the panel to the meassurements, and test fit without sealant.
    Clean the cutting edges, the sealing lip and other edges.
    D)
    Sealant
    Apply approved sealant to the lower edge as shown on the drawing.
    Work the sealant with the Fibo Fug Sealant Tool.
    E)
    Screw the panels
    Attatch the panel to the studs as shown on the drawing.
    Use a screw every 200mm.
    F)
    Cleaning and sealing
    Clean the edges on both the receiving panel and the one about to be fitted, and prepare them both for sealant.
    Apply the sealant to the meeting edges, before the panel is clicked into place
    It is important to use enough sealant to make sure the seals are watertight.
    The sealant should be overflowing consistently all along the seam.
    G)
    Applying and cleaning of excess sealant
    When the seam is completely covered with sealant consistently, the excess can be cleaned off. Spray Fibo Clean on all overflowing sealant. Then run the Fibo Fug sealant tool to remove all overflowing sealant. If there is any remaining sealant after, it can be wiped off with Fibo Wipes.
    H)
    Final panel
    Before the final panel is installed, test fit it before applying sealant.
    I)
    Install it
    Swing the final panel in from the left, and click it into place on the right side.
    J)
    Sealing the inside corner
    Should there be a gap between the panel and the inside profile after the panel is clicked into place, then this gap must be filled with sealant.
    Apply a roughly 5mm thick line of Fibo Seal from bottom to top on both panels that meet at the corner.
    Roughly 4-5mm out from the corner.
    After the second part of the panel is installed, the covering profile can be installed.
    This is pushed into the innerprofile with the lower part first.
    Use a tapping block gently to get it into place should it prove difficult.
    K)
    Assemble the visible part of the corner

    The sealant must overflow along the profile's length, in a consistent manner.
    The overflowing sealant is cleaned off with the Fibo Clean and Fibo Fug sealant tool, aswell as wiping it down with Fibo Wipes.

    L)
    Sealing the base
    Apply sealant as shown on the drawing.
    Remember that membrane needs to be a minimum of 45mm over tile edging.
    Always use certified sealant to get the room certified according to the wet room standard.
    M)
    Plumbing
    Drill a hole that is 5mm bigger in diameter than the pipe.
    Edges of the hole is cleaned after the drilling, and have sealant applied to it.
    Use approved pipe grommets like Sanipex or similar.

    Contact us

    Mail: ordre@fibosystem.com     Customer service: +47 38 34 33 00     Main office: +47 38 34 33 00

    Follow us on Facebook and Instagram