Kitchen Board without bottom strip

Kitchen Board without bottom strip

No Fibo favorites here yet.

    1. Kitchen Board without bottom strip

    Meassure and adjust
    Meassure the area and cut the panels so they fit the meassurements.
    Adjustment for height is to be done at the top of the panel.
    Remember to adjust for any overlap.
    You need to predrill and use an apropriate wall anchor, if the kitchenboard is to be mounted on a brickwall.
    Find the studs and use them to attatch the panels.
    Adjust bottom spacing
    There needs to be a 2-3mm gap from the countertop and up to the bottom edge of the kitchenboard.
    Predrilling of the panel for the inside corner
    Prior to installation, the holes in the panels needs to be predrilled to avoid damage to the panel.
    Screw it in the edges.
    The panels are clicked together  
    Sealant in seam behind sink
    It is recomended to apply sealant between panels behind the sink.
    Apply it before clicking the panels together.
    The edge must be predrilled
    After predrilling and countersinking, the final panel can be screwed in.
    The screwes are covered by a sidelist.
    Sealing the gap
    The gap between the countertop and kitchenboard is sealed at the end.
    Overflowing sealant is to be cleaned with Fibo Clean and the Fibo Sealant tool.

    Contact us

    Mail:     Customer service: +47 38 34 33 00     Main office: +47 38 34 33 00

    Follow us on Facebook and Instagram